Securing the stand to a countertop
1.
Remove the cover from the neck of the stand
1
, and then
slide the base cover forward and lift it off the base
2
.
2.
Fasten the stand to a countertop using the appropriate
fastening devices (not provided by HP) for your surface.
3.
Slide the base cover onto the base of the stand
1
, and
then replace the neck cover on the neck of the stand
2
.
Adjusting the stand
Adjust the display head to the appropriate position for your
application. The suggested working angle is -5 degrees to 80
degrees.
Removing the stand
1.
Lay the RP9 face down on a flat surface covered by a soft
clean cloth.
2.
Push up the release latch on the rear of the display head
1
, tilt the stand back
2
, and then lift the stand from the
display head
3
.
Documentation feedback
HP is committed to providing documentation that meets your
needs. To help us improve the documentation, please send any
suggestions, comments, or errors to doc.feedback@hp.com.
Include the document title and part number (located near the
barcode) when submitting your feedback.
