Memory
The memory modules
(2)
are located under the memory cover under left rear cover. You do not have to
remove the computer from the column to replace the memory modules.
SODIMMs are small outline dual-inline memory modules. SODIMM modules must meet the following
requirements:
●
204-pin DDR3L SODIMM
●
PC3L-12800 (1600 MHz) DDR3L-SDRAM
●
Unbuffered, non-ECC (64-bit) DIMMs
●
1.35 V memory only
●
16 GB maximum installable memory
NOTE:
Because the memory uses dual channels, you must use the same SODIMM type for both sockets.
The actual memory transfer speed might vary based on the processor used in your computer.
Memory performance might vary due to different system configurations.
There are two memory sockets on the system board located behind the memory cover. To remove or install
memory modules:
To remove a memory module:
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 25
).
2.
Remove the left rear cover (see
Removing the rear covers from the computer on page 26
).
30
Chapter 4 Removal and Replacement Procedures – Computer
ENWW
Summary of Contents for Sprout
