Samsung: CON820
CAUTION:
Incorrect jumper placement can result in damage to the converter board and display panel.
To install a display panel, reverse the removal procedures.
Updating BIOS with new display panel information
If you install a display panel from a different manufacturer than what was previously installed (for example,
replace an LG panel with a Samsung panel), you need to update BIOS with the new panel information. Failure
to do so may cause the new panel to function incorrectly.
To update BIOS with the new panel model information:
1.
Boot the computer.
2.
Repeatedly press
F10
when the monitor light turns green to access the F10 Setup utility.
3.
Select
Advanced
, select
Device Options
, select
LVDS Panel Select
, and then select the manufacturer
for the new display panel.
4.
Save your settings, exit F10 Setup, and allow the computer to continue to the operating system.
When you change the LVDS setting to the installed panel type, the BIOS reprograms the EDID with the correct
data. You must set the panel before the Auto-select setting functions correctly.
ENWW
Display assembly
75
Summary of Contents for Sprout
