Table 18 8/8, 8/24 and 8/40 SAN Switch memory
Install memory
Memory type
512 MB
Main Memory (SDRAM)
8/40 SAN Switch only: 4 MB
Boot Flash
1 GB
Compact Flash
lists the 8/80 SAN Switch, Encryption SAN Switch, and FCoE Converged Network Switch
memory specifications.
Table 19 8/80 SAN Switch, Encryption SAN Switch, and FCoE Converged Network Switch memory
Install memory
Memory type
1 GB
Main Memory (DDR2 SDRAM)
4 MB
Boot Flash
1 GB
Compact Flash
lists the 1606 Extension SAN Switch memory specifications.
Table 20 1606 Extension SAN Switch memory
Install memory
Memory type
2 GB
Main Memory (DDR2 SORDIMM SDRAM)
4 MB
Boot Flash
1 GB
Compact Flash
Facility requirements
To ensure correct operation, the facility where the switch is in use must meet the requirements shown
in
Table 21 Facility requirements
Requirements
Type
8/8, 8/24, 8/80, Encryption, and 1606 Extension SAN Switches
—Primary AC input:
100–240 VAC, 2.0 A, 47–63 Hz; switch autosenses input voltage.
8/40 SAN Switch
—Primary AC input: 90–264 VAC; switch autosenses input voltage.
FCoE Converged Network Switch
—Primary AC input: 85–264 VAC; input line frequency
47–63 Hz.
Adequate supply circuit, line fusing, and wire size, as specified by the electrical rating on
the switch nameplate.
Circuit protected by a circuit breaker and grounded in accordance with local electrical
codes.
Electrical interference less than the levels in the standards listed in
Electrical
Technical specifications
86
