5. RJ-45 management port
1. Status LED
6. RJ-45 serial console port
2. Power LED
7. USB port
3. RJ-45 GE ports (for clustering and re-keying)
8. Fibre Channel ports (0–31)
4. Smart Card reader
Figure 6 Port side of the Encryption SAN Switch
.
FCoE Converged Network Switch features
The FCoE Converged Network Switch has the following features:
•
Includes a system motherboard with a Freescale MPC8548 RISC CPU running at 1.3 GHz and
integrated peripherals, that provides high performance with low power consumption
•
Contains an RJ-45 Ethernet management port and EZSwitch Setup, which supports switch IP address
discovery and configuration
•
Integrates a USB port that provides storage for firmware updates, as well as
supportsave
command output and configuration uploads and downloads
•
Provides two hot-swappable, redundant power supply FRUs
•
Provides three hot-swappable fan FRUs in an N+1 configuration to provide hardware-redundant
cooling
•
Includes universal ports that self-configure as E_Ports, F_Ports, M_Ports, or FL_Ports
•
Provides extensive diagnostics and system-monitoring capabilities for enhanced RAS
•
Provides FCoE-to-FC latency of 1,670 ns
The FCoE Converged Network Switch has the following Ethernet capabilities:
•
Contains 24 ports, 10-GbE CEE
•
Provides low-latency, lossless, deterministic interconnect required for FCoE
•
Provides FCoE support with FPMA discovery. Fabric OS also enables support for Priority-based
Flow Control (802.1Qbb)
•
Includes DCBX - Capabilities Exchange and Enhanced Transmission Selection (802.1Qaz) to meet
the lossless and deterministic FCoE requirement
•
Enables hardware-assisted MAC learning and aging
•
Support for 32,768 MAC addresses and 4,096 VLANs
•
Support for Layer 2 protocols STP/MSTP/RSTP (802.1q) and Link Aggregation (802.1ad)
•
HP branded 10-Gb SFP+ (SR and LR) and active copper cables
•
Provides CEE port to CEE port latency of 570 ns (same ASIC) and 1,050 ns (different ASIC)
HP StorageWorks 8-Gb SAN Switches
20
