7.
Secure the two inner rails (one on each side) to the device, using the appropriate number of
screws (see
).
For example,
shows an inner rail attached to the MP Router with three screws, using
the two rail screw holes marked
R
and one marked
16
. Attaching both rails requires six screws.
This figure also applies to the Encryption SAN Switch, FCoE Converged Network Switch, and
1606 Extension SAN Switch.
shows an inner rail attached to the 4/64 SAN Switch with five screws, using the rail
screw holes marked
16
. Attaching both rails requires ten screws. This figure also applies to the
8/8, 8/24, 8/40, and 8/80 SAN Switches.
Figure 19 Securing the inner rails to an MP Router
.
Figure 20 Securing the inner rails to the 4/64 SAN Switch
.
NOTE:
For factory integration
only, tighten the #8-32 x 5/16-inch Phillips panhead SEMS screws
and torque between 6 and 8 inch-pounds.
8-Gb SAN Switch Hardware Reference Guide
41
