54
HP StorageWorks 2012i Modular Smart Array user guide • March 2008
■
Data host IP addresses may not be set correctly
■
Controller enclosure host port addresses may not be set correctly on the data host
■
Cables between the controller enclosure and/or switches and/or data hosts may
not be connected correctly
Correct the issue, return to the Targets tab and click Refresh.
6. If two targets are configured, select the first target (controller module) and click Log
On.
7. On the Log On to Target dialog, set the following options:
a. For connectivity settings to persist across system reboots, check Automatically
Restore this Connection When the System Boots.
b. For fault-tolerant configurations, select Enable Multi-path.
c. Click Advanced to set connectivity settings as follows:
i. At the Local Adapter field, select Microsoft iSCSI Initiator from the drop-
down menu.
ii. At the Source IP field, select the IP address for the local data Ethernet port
that is on the same subnet as the first target portal (iSCSI host port) to which
you want the host to connect.
iii. At the Target Portal field, select the IP address for the iSCSI host port on the
target (controller module) to which you are connecting.
iv. Repeat the log on procedure (Step i through Step iii) to initiate connectivity for
the second target portal on the selected target.
8. To allow LUN access through all available ports during failover, change default
multipathing settings as follows:
a. On the Targets tab, select the target and click Details.
b. On the Devices tab of the Target Properties dialog, select the first device and
click Advanced.
c. On the MPIO tab of the Device Details dialog, select Round Robin from the Load
Balance Policy drop-down menu and click OK.
d. Repeat Step b and Step c for all devices listed.
9. Repeat tasks in Step 6, Step 7, and Step 8 for the second target.
