1. Mounting tabs (2)
2. Blower
Figure 32 Removing a blower
Replacing a blower
CAUTION:
Pressing on the center section of the blower can damage the blades or the housing. Only press on
the outer edge of the blower.
To replace a blower:
1.
Align the blower guide post (
Figure 33
-2) with the mounting hole next to the power supply
connector (
Figure 33
-1).
2.
Slide the blower onto the blower base (
Figure 33
-4) until the mounting tabs (
Figure 33
-3) snap
into place.
3.
Verify that the blower starts and the power supply/blower assembly LED is on.
60
Customer self repair
Summary of Contents for StorageWorks 2500
