122 Servicing & Upgrading
Midplane Assembly
Caution
—
To prevent data loss, it is recommended that a full backup be performed
before removing a midplane assembly.
—
The midplane assembly can be damaged by electrostatic discharge.
Use the ESD kit provided when removing and installing the midplane
assembly.
—
The midplane assembly is tied directly to the enclosure. Once a
midplane assembly has been installed in an enclosure, you cannot re-
use it in another enclosure. The serial number and worldwide name
(WWN) of the enclosure are stored in redundant EEPROMs on the
midplane assembly.
Removing a Midplane Assembly
(HP Service Personnel Only)
1
Perform an array shutdown.
2
Remove all of the disk drives. See
"Removing a Disk Drive" on page 98
.
Note
The controllers and power modules do not need to be completely
removed from the array chassis - only disengaged.
3
Disengage the array controller cards 1 inch (2.5 cm) from the midplane.
See
"Removing an Array Controller" on page 107
.
4
Disengage the power modules 1 inch (2.5 cm) from the midplane. See
"Removing a Power Module" on page 102
.
5
Racked arrays only
: Remove the chassis mounting screws from the rack
and pull the array chassis 2 inches (5 cm) out of the rack.
Note
Verify that pulling the array chassis out of the rack will not stress
or damage the cables connected to the rear of the chassis.
Deskside arrays only
: Remove the chassis from the deskside assembly (see
HP StorageWorks VA 7100 Deskside Assembly Conversion Kit
Instructions)
.
6
Remove the front bezel (
Figure 49
, 1).
7
Remove three T-10 screws (2) from the chassis top cover (6).
Summary of Contents for StorageWorks 7110 - Virtual Array
