•
Time zone settings persist across failover for high availability.
Setting the time zone
IMPORTANT:
The following procedure describes how to set the time zone for a switch. You must perform the
procedure on all switches for which the time zone must be set. However, you only need to set the time
zone once on each switch, because the value is written to nonvolatile memory.
1.
Log in to the switch using the default password,
(password)
.
2.
Enter the
tsTimeZone
command:
switch:admin> tstimezone
[
--interactive
]/ [,
timezone_fmt
]
Use
timezone_fmt
to set the time zone by Country/City or by time zone ID, such as PST. The
following example shows how to change the time zone to US/Central:
switch:admin> tstimezone
Time Zone : US/Pacific
switch:admin> tstimezone US/Central
switch:admin> tstimezone
Time Zone : US/Central
To set the time zone using interactive mode:
1.
Type the
tsTimeZone
command:
switch:admin> tstimezone --interactive
2.
You are prompted to select a general location.
Please identify a location so that time zone rules can be set correctly.
3.
Enter the appropriate number or
Ctrl-D
to quit.
4.
At the prompt, select a country location.
5.
At the prompt, enter the appropriate number to specify the time zone region or
Ctrl-D
to quit.
Synchronizing local time using Network Time Protocol (NTP)
You can synchronize the local time of the principal or primary Fabric Configuration Server (FCS)
switch to a maximum of eight external NTP servers. To keep the time in your SAN current, it is
recommended that the principal or primary FCS switch has its time synchronized with at least one
external NTP server. The other switches in the fabric will automatically take their time from the principal
or primary FCS switch.
All switches in the fabric maintain the current clock server value in nonvolatile memory. By default,
this value is the local clock server
<LOCL>
of the principal or primary FCS switch. Changes to the
clock server value on the principal or primary FCS switch are propagated to all switches in the fabric.
For more information on using an NTP server, and IPv6 considerations, see the
HP StorageWorks
Fabric OS 6.1.x administrator guide
and the
HP StorageWorks Fabric OS 6.2.x administrator guide
.
1.
Log in to the switch using the default password:
password
.
8-Gb SAN Switch hardware reference manual
51
Summary of Contents for StorageWorks 8/24 - SAN Switch
