4/256 SAN Director blade support
Fabric OS 6.2.0g is fully qualified and supports the Director blades listed in
Table 2
.
Table 2 4/256 SAN Director blade support matrix
Number of blades
Director blade
Supported with any mix with up to eight blades of each
type. No intermix restrictions. The 4/256 SAN Director
must run Fabric OS 6.0.0b or later to support the FC8-
16 port blade, and Fabric OS 6.1.0a or later to support
the FC8-32 and FC8-48 port blades.
FC4-16
FC4-32
FC4-48
FC8-16
FC8-32
FC8-48
FC10-6
Up to four blades of this type
FC4-16IP (iSCSI blade)
Up to two blades of this type. Up to eight FR4-18i blades
can be installed if they are used only for FC Fast Write
or FCIP without routing.
FR4-18i (FCIP/FC Router blade)
DC SAN Backbone and DC04 SAN Director blade support
Fabric OS 6.2.0g is fully qualified and supports the DC Director blades listed in
Table 3
.
Table 3 DC Director blade support matrix
Number of blades
Director blade
Supported with Fabric OS 6.0.0b or later with any mix,
with up to eight blades of each type on the DC SAN
Backbone Director. There are no intermix restrictions. The
DC04 SAN Director requires Fabric OS 6.2.0a or later,
and supports up to four blades.
FC8-16
FC8-32
FC8-48
FC10-6
Not supported with the DC SAN Backbone Director or
DC04 SAN Director
FC4-16IP (iSCSI blade)
Supported with Fabric OS 6.0.0b or later, with a maximum
of four blades of this type on the DC SAN Backbone
Director. Up to eight FR4-18i blades can be installed if
they are used only for FC Fast Write or FCIP without routing
in the DC SAN Backbone Director. The DC04 SAN Director
requires Fabric OS 6.2.0a or later, and supports up to
four blades.
FR4-18i (FCIP/FC Router blade)
Supported with Fabric OS 6.2.0b or later, with a maximum
of four blades of this type on the DC SAN Backbone Dir-
ector or DC04 SAN Director
FS8–18 (DC Switch Encryption FC blade)
HP StorageWorks Fabric OS 6.2.0g release notes
15
