Internal Tape Drive Installation
34
DLT VS 40/80 GB Tape Drive Reference Guide
Note:
Your server may differ from the following illustrations; refer to the documentation
included with your server.
Figure 10: Installing an internal drive
3. Install an LVD/SE SCSI host adapter in the server that is to be the host for the
drive, if necessary.
4. If necessary, attach the drive rails that ship with the drive.
Note:
Your server may supply rails in the drive bay. Refer to your server user guide for
information on the correct rails to use with your server.
5. Insert the drive into an available 5 1/4-inch drive bay.
Note:
You may need to remove the front cover from the drive bay. Refer to the
documentation included with your server.
6. Secure the tape drive into the server according to the documentation included
with the server.
7. Connect an available power cable and the wide SCSI signal cable.
SELE
CT
ENTE
R
EJEC
T
Summary of Contents for StorageWorks DLT VS 40
