e1200-320 4Gb Fibre Channel Interface Card user and service guide 117
E
Enabling DHCP on the HP e1200-320 4Gb FC
Interface Card
DHCP, or Dynamic Host Configuration Protocol, is an open industry standard that simplifies administering
networks based on Transmission Control Protocol/Internet Protocol (TCP/IP). DHCP allows network
resources to go farther by enabling a unique IP address to be assigned to a specific device (interface
card, client host, etc.) on a non-permanent, dynamic basis.
DHCP makes network administration easier—the larger the network, the greater the benefit. DHCP
accommodates larger networks because it can assign temporary IP addresses for a specified time interval.
DHCP frees network administrators from having to configure each interface card or host manually.
Other benefits of a DHCP environment include:
•
No additional address configuration is required for client hosts.
•
IP addresses can be reused or leased for specific time periods.
•
IP address assignment is better managed. For example, if the IP address for an interface card in a
network changes and 250 client computers have to be updated with the new address, you do not
have to manually reconfigure every workstation.
Without DHCP, permanent IP address configuration is the only option. This means a network
administrator is required to manually configure a permanent IP address for each individual interface card
or client host. Permanent IP addresses require more network resources, but are useful when dealing with
smaller LAN environments. Without dynamic address assignment, interface cards and hosts have to be
configured manually one by one. IP addresses must be managed to avoid duplicate use, and changes
must be applied to clients by hand. Configuration information is not centralized, and it is difficult to get a
view of all interface card or host configurations.
The use of TCP/IP and DHCP both contribute to networking and the growth of the Internet. TCP/IP uses
open protocol standards that enable the forming of wide area networks (WANS). For each interface card
to identify itself on a TCP/IP network, it must be uniquely identified by the following information:
1.
An IP address: a 32-bit field composed of four octets (8-bit numbers from 0 through 255). Each
address has decimal notation to separate octet numbers, such as 208.24.132.184.
Your DHCP server may allow you to set up a lease reservation for an IP address by providing the
server with the Ethernet MAC address of the interface card. This sets the DHCP server to always
provide the same IP address to the interface card. This setup can be useful for remote management of
the interface card via Telnet or Visual Manager. Because the method of setting up a lease reservation
varies depending on the DHCP server being used, it is recommended you contact your Network
Administrator for assistance.
2.
A subnet mask: This indicates how the IP address is to be read. It also indicates how to separate the
network identifying information from the interface card identifying information so the IP address can
be interpreted correctly. For example, if a subnet mask of 255.255.255.0 is applied for an address
10.85.189.24, it indicates that the unique interface card address is 24, located on the 10.85.189
subnetwork.
3.
A default gateway: This is used to specify the address for the nearest interface card that is used by the
host device to forward addressed packets on to the network.
These previous three options (IP address, subnet mask, and gateway) are necessary for effective DHCP.
Summary of Contents for StorageWorks e1200-320
