Chapter 1
Setting Up the HP Server
4
6e) Replacing the covers
•
Ensure all cables are properly routed
and all components are fully seated,
before replacing the covers.
•
For details refer to Chapter 3,
"Opening and Closing the HP
Server."
Applying Power to the Server
7) Check/Set the Power
Supply Input Voltage
•
Check the input voltage switch on the power
supply located on the rear of the Server below
the power connector, as shown below.
•
The input voltage switch has two positions: 115
or 230 volts – 230 volts is default position.
(Switch shown in
115 volts position.)
Input Voltage
Switch
Power
Connector