Chapter 5
Installing Additional Memory
38
•
DIMM sizes may be mixed on the system board and may be loaded in any
order (1 through 3).
However, HP recommends starting at slot 1 and filling the slots in order with
the largest size first: 1, 2, and 3.
•
Open slots between DIMMs are permitted.
•
When handling DIMMs, observe anti-static precautions to avoid damage.
Installing Additional DIMMs
1. If the system is already installed and working, power down the system.
Refer to Chapter 2, "Controls, Ports, and Indicators."
2. Disconnect the power cables and any external cables connected to the system.
If necessary, label each one to expedite re-assembly.
3. Remove the side cover and lay it aside.
Refer to Chapter 3, "Opening and Closing the HP Server."
WARNING
The power supply will continue to provide standby current to
the Server tc2100 until the power cable is disconnected.
4. Lay the Server on its side (components showing) for the best access to the
DIMM slots.
CAUTION
The memory modules (DIMMs) are sensitive to static
electricity and can be easily damaged by improper handling.
Do the following when handling the accessory kit:
Leave the memory module in the anti-static container until
you are ready to install it.
Always use an anti-static wrist strap and a grounding mat.
Before you remove a memory module from the anti-static
container, touch a grounded, unpainted metal surface on the
HP Server to discharge static electricity.