44
Chapter 3
Installing and Configuring
Processors
Introduction
The HP Server tc4100 supports two processors that must operate at the same speed and cache size. Both
processors sockets are located on the system board.
The HP Server tc4100 supports the Pentium III processors at a front side bus (FSB) speed of 133 MHz.
Advanced processors may be supported as each one becomes available. Contact HP or your reseller for details.
The Server ships with one processor in the primary processor socket.
Tools Required
An antistatic service kit (3M™ 8501/8502/8503 or equivalent). This kit includes a static-dissipating work
surface, a chassis clip lead, and a wrist strap.
Processor Configuration Guidelines
The HP Server tc4100 supports a variety of processor speeds with an FSB speed of 133 MHz.
•
Both processor modules must be the same processor type and have the same product number, which insures
the same clock speed, cache size, and FSB speed.
•
The processor modules must operate at the designated speed stated by the product type on the processor.
•
Use only processor upgrade kits with the same HP product number. This ensures the processor type, clock
speed, and cache size match, and that product numbers are compatible.
•
If you want to upgrade the primary processor, you do not have to remove the termination card.
CAUTION
Do not open the new processor's protective bag or remove it from the bag until you are
ready to install it.
Before you remove a processor from the antistatic container, touch a grounded, unpainted
metal surface on the HP Server tc4100 to discharge static electricity.
CAUTION
Do not set the processor speed switches to any other speed, as this can result in unreliable
or intermittent performance, and data integrity may also be at risk.
