Removing a wireless module from model 2510p
In model 2510p, the slot for the wireless module is located in the WWAN
module compartment on the bottom of the computer.
Follow the procedure below to remove an HP Broadband Wireless
Module from the WWAN module compartment
CAUTION:
To reduce the risk of damage to electronic components,
discharge yourself of static electricity by touching a grounded metal
object before you begin the following procedure.
CAUTION:
Do not pull on an antenna cable to remove it. Gently grip
and pull only on the connector itself. Pulling on the cable can damage
the connector or break it off the cable.
1
.
Carefully disconnect the wireless module antenna cables
(1)
from
the wireless module by lifting the cable connectors with your
fingernails or a small screwdriver.
2
.
Remove the 2 Phillips screws
(2)
that secure the wireless module to
the computer. (The edge of the module opposite the slot rises away
from the computer.)
3
.
Slide the wireless module
(3)
away from the slot
(4)
at an angle.
30
Chapter
4
Removing an HP Broadband Wireless Module
Summary of Contents for UNDP-1H
