English
29
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
Installing Mass Storage Devices
This section describes the data connectors that you can use when you
install an extra IDE mass storage device. For detailed installation
instructions, refer to the
Upgrade and Maintenance Guide
, available
on HP’s web site at
http://www.hp.com/go/vectrasupport/
.
You can install extra IDE mass storage devices such as a supplementary
hard disk drive, a Zip drive, a CD-ROM drive, and a tape drive. Up to
two hard disk drives can be installed in your PC.
NOTE
You can install a non-IDE hard disk drive or CD-ROM device, but it will
need an accessory board, cable and driver software (usually supplied
with the device). Contact the product vendor for further information.
Connecting Devices
If you add a Zip drive, hard disk drive, CD-ROM drive, or tape drive,
you need to connect it to power and data cables. The data cables
available in your PC are shown below:
IDE CD-ROM cable
Master (end) connector
Floppy drive data
cable (non-IDE)
IDE CD-ROM cable
Slave (middle) connector
Ultra ATA IDE HDD cable
Slave (middle) connector
Ultra ATA IDE HDD cable
Master (end) connector
Summary of Contents for Vectra VL6 8
Page 1: ...HP Vectra VL series 8 User s Guide ...
Page 3: ...User s Guide PN D5908 90001 ...
Page 8: ...vi English ...
Page 9: ...1 Setting Up and Using Your PC ...