English
99
4 Troubleshooting Your Personal Workstation and Using the Setup Program
Using the HP Setup Program
SCSI Device
Configuration Menu
This menu lets you configure parameters for each SCSI device on the
SCSI bus. To configure a specific SCSI device, you need to know which
SCSI ID it uses.
Use the
and
keys to move between options. Press
to
display a menu with a selection of values.
•
Initiate Sync Negotiation
Some older SCSI-1 devices do not support synchronous negotiation.
Set Initiate Sync Negotiation to
No
for these devices.
•
Maximum Sync Transfer Rate
Certain older SCSI-1 devices do not support Fast SCSI data transfer
rates (typically 10.0, 8.0, and 6.7). Select a Maximum Sync Transfer
Rate of 5.0 for these devices.
•
Enable Disconnection
To optimize SCSI bus performance, Enable Disconnection should be
set to
Yes
when two or more SCSI devices are connected to the host
adapter. Set Enable Disconnection to
No
to achieve slightly better
performance when only one SCSI device is connected to the SCSI
bus.
SCSISelect(TM) Utility v1.xxx
SCSI Device Configuration
SCSI Device ID
#0
#1
#2
#3
#4
#5
#6
#7
Initiate Sync Negotiation... yes
yes
yes
yes
yes
yes
yes
yes
Maximum Sync Transfer Rate.. 10.0 10.0 10.0 10.0 10.0 10.0 10.0 10.0
Enable Disconnection........ yes
yes
yes
yes
yes
yes
yes
yes
Options Listed Below Have NO EFFECT if the BIOS is Disabled
Send Start Unit Command....
no
no
no
no
no
no
no
no
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit
Summary of Contents for VECTRA XW
