1 Setting Up Your Personal Workstation
Connecting a SCSI Accessory
8
Connecting a SCSI Accessory
Note that Ultra SCSI mode is disabled automatically when an external
SCSI accessory is connected to your Personal Workstation.
1
Refer to the manual provided with the SCSI accessory for
instructions on selecting a SCSI address. You should assign an
unused SCSI address to the accessory.
SCSI addresses range from 0 to 7, with SCSI address 0 used by the
first SCSI hard disk drive and SCSI address 7 reserved for the
integrated SCSI controller.
NOTE
You don’t need to set a SCSI address for Plug and Play SCSI devices
(SCSI devices which support the SCAM protocol).
2
Connect the SCSI accessory to your Personal Workstation’s external
SCSI connector with a shielded SCSI cable. (Note that Ultra SCSI is
automatically disabled when an external SCSI accessory is
connected.)
Summary of Contents for VECTRA XW
