English
45
3 How to Install Accessories Inside Your Personal Workstation
Installing Main Memory
3
Slide each memory module into the slot at 90° to the system board
(hold the memory module with the cutouts closest to the processor).
4
Firmly
press each memory module
completely
into the connector
until the retaining clips click into position.
5
Repeat this procedure for each pair of memory modules you are
installing.
6
Install any other accessories before replacing the cover (see page
38). Reconnect all cables and power cords.
Completing the Main Memory Installation Procedure:
1
Switch on the Personal Workstation. When
Error 0250
appears
(indicating that the Power-On-Self-Test has detected a change in
your memory configuration) follow the displayed instructions to run
the
Setup
program.
2
Check that
Setup
has automatically detected and configured the
Memory Size
fields. Ensure the
TOTAL
memory is correct. If it is
incorrect, check that you have correctly installed the memory
modules.
3
Set the extended memory limit field to
Y
if you use software designed
for i286 processors (or earlier processors) that cannot work with
more than 16 MB total memory.
4
Press
to save and exit the
Setup
program.
Slide the memory module into
the slot at 90
o
Push the module until the retaining clips
click into position
Summary of Contents for VECTRA XW
