4 Troubleshooting Your Personal Workstation and Using the Setup Program
If Your Personal Workstation Does Not Start
70
English
If Your Personal Workstation Does Not Start
If Your Display is Blank and There Are No Error Messages
1
Make sure that all cables and power cords are firmly plugged in.
2
Make sure the power outlet is working.
3
Check that the computer and display are turned on. (The power light
should be illuminated.)
4
Check the display’s contrast and brightness settings.
5
If the Personal Workstation still does not work:
a
Turn off the display, the computer, and all external devices.
b
Unplug all power cords and cables, noting their positions.
c
Remove the cover (refer to page 38).
d
Check that the processor is correctly installed (refer to page 63).
e
Check that the memory modules are correctly installed (refer to
page 44).
f
Check that accessory boards are firmly seated in their slots (refer
to page 46).
g
Verify that any switches and jumpers on the accessory boards are
properly set (refer to the manuals that came with each board).
h
Check that the switches on the system board are properly set
(refer to page 115).
i
Replace the cover (refer to page 40).
j
Connect all cables and power cords (refer to chapter 1).
k
Turn on the display and computer.
If your Personal Workstation still does not start, remove all boards and
accessories, except the hard disk drive and the video board. Start the
Personal Workstation. If it now works, add the boards and accessories
one at a time to determine which one is causing the problem.
Summary of Contents for VECTRA XW
