4 Troubleshooting Your Personal Workstation and Using the Setup Program
If Your Personal Workstation Has a Hardware Problem
76
English
If Your Personal Workstation Has a Hardware Problem
This section describes what to do if you have problems with your
display, disk drives, printer, accessory boards, keyboard, or mouse.
If Your Display Does Not Work
If nothing is displayed on the screen, but the Personal Workstation
starts and the keyboard, disk drives, and other peripheral devices seem
to operate properly:
1
Check that the brightness and contrast controls are properly set.
2
Make sure that the display is plugged in and switched ON.
3
Ensure that the display video cable is correctly connected to the
display and to the Personal Workstation.
4
Switch off the display, and unplug it from the power outlet. Examine
the video cable pins to see if they are bent. If they are, carefully
straighten them.
If the display image is not aligned with the screen (usually when you
change resolutions), use the display’s controls to center the image.
Refer to the display manual for instructions.
If the screens generated by your software applications do not appear
correct, check the application’s manual to find out which video
standard is required. Also check your display manual to find out which
refresh rate is required. Use the HP
Setup
program to select the
correct refresh rate.
If the display works correctly during the Power-On-Self-Test (POST),
but goes blank when the operating system starts, restart the Personal
Workstation and check that the amount of video memory detected by
the POST is correct.
Summary of Contents for VECTRA XW
