4 Troubleshooting Your Personal Workstation and Using the Setup Program
If Your Personal Workstation Has a Software Problem
82
English
If You Can’t Start the
Setup
Program
This may happen if the copy of the Personal Workstation’s
configuration stored in memory is corrupted. You will need to erase
this bad configuration.
To clear the configuration:
1
Switch off the Personal Workstation and remove the cover (refer to
chapter 3).
2
Set the system board switch 1 (CONFG) on the switch block to ON
to clear the configuration (refer to page115 for the switch location).
3
Replace the cover and switch on the Personal Workstation to erase
the memory.
4
Check that error codes
0240
and
0130
are displayed, and wait until
the Personal Workstation has started.
5
Switch off the Personal Workstation and remove the cover.
6
Set the system board switch 1 (CONFG) on the switch block to OFF
to re-enable the configuration.
7
Replace the cover (refer to chapter 3).
8
Switch on the Personal Workstation and run
Setup
by pressing
when
<Setup=F2>
appears. (Error code
0130
will appear when the
Personal Workstation starts.)
9
Press
to save the configuration and exit from
Setup
.
If the Date and Time Are Incorrect
The date and time can be incorrect because the time has changed for
the seasons, or because the Personal Workstation has been unplugged
from the power too long, and the Gold Capacitor which supplies power
to the CMOS memory has discharged. To recharge the Gold Capacitor,
plug the Personal Workstation into the power for one hour (there is no
need to start the Personal Workstation).
You can install an external battery that will keep track of the date and
time if the Personal Workstation is unplugged for more than one week
(the external battery connector is shown on page 114). Contact your
HP dealer for complete information about installing an external
battery.
Use the
Setup
program to change the date and time.
Summary of Contents for VECTRA XW
