Service and Technical Reference Guide, xw3100
338611-001
5–3
Removal and Replacement Procedures
5.3 Hood
Sensor
1. Prepare the workstation for disassembly (Section
5.1
).
2. Remove the workstation access panel (Section
5.5
).
3. Remove the front bezel (Section
5.6
).
4. Raise the drive cage to its upright position
1
.
5. Slide the hood sensor switch towards the inside of the workstation
2
.
6. Disconnect the hood sensor cable from the system board
3
.
To install the hood sensor, reverse the removal procedure.
Summary of Contents for Workstation xw3100
