Power switch cable assembly
This section describes how to remove and install the power switch cable assembly.
Removing the power switch cable assembly
1.
Disconnect power from the workstation (see
Predisassembly procedures on page 77
).
2.
Remove the side access panel (see
Removing the side access panel on page 79
).
3.
Remove the expansion card support (see
Removing the expansion card support on page 82
).
4.
Remove the expansion card guide/front fan holder (see
Removing the expansion card guide/front
fan holder on page 141
).
5.
Remove the right side panel (see
Removing the right side panel on page 86
).
6.
Remove the front bezel (see
Removing the front bezel on page 91
).
7.
Disconnect the speaker (see
Removing the speaker on page 87
).
8.
Cut the cable ties (1), and then move the power switch cable assembly screw (2), as shown in the
following figure.
Figure 5-20
Loosening the power switch cable assembly
9.
Remove the cable assembly by pulling cables through the lower right chassis wall opening and the
front chassis wall opening.
96
Chapter 5 Replacing components
ENWW
