Solid-state drive (M.2)
Description
Spare part number
256 GB Solid-state drive (SSD), M.2
788297-001
128 GB solid-state drive (SSD), M.2, TLC
777774-001
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
Bottom cover on page 28
).
5.
Disconnect the battery.
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×3.5 screw
(1)
that secures the solid-state drive to the system board.
2.
Remove the solid-state drive
(2)
by pulling the drive away from the slot at an angle.
34
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
