5.
As shown in the following figure, place the SATA hard drive in the drive bracket, and align the four
threaded screw holes in the hard drive body with the four matching screw holes in the inner bracket
flanges.
Figure 4-54
Installing the hard drive in bracket
6.
Install four silver ANSI 6–32 screws through the oversized holes in the bracket outer flanges, and
into the bracket inner flanges and hard drive body, as shown in the figure above.
The hard drive body should be securely mounted within the mounting bracket.
7.
As shown in the following figure, lift the locking lever on the left as you start to insert the drive and
bracket into the respective optical drive bay until it locks into place, and then check for secure fit.
Figure 4-55
Installing the hard drive in an optical drive bay
ENWW
Removing and replacing components
95
Summary of Contents for Xw6600 - Workstation - 2 GB RAM
