d.
(If installing side access panel sensor) Carefully route the side access panel sensor cable
along the drive bay and plug it into the HSENSE connector on the system board (4).
NOTE:
To locate system board components, see the service label on the side access panel
Figure 5-36
Installing the fan holder/card guide assembly
12.
Make sure that none of the cables are pinched by the fan holder/card guide assembly.
13.
Replace components removed during this procedure: )
a.
Replace the front bezel (see
Installing the front bezel on page 83
).
b.
Replace any expansion cards that you removed (see
Installing an expansion card
on page 127
), making sure that the cables will not interfere with the expansion cards. The
slots in the fan holder/card guide will now help secure any full-length expansion cards.
c.
Replace the side access panel (see
Installing the side access panel on page 78
).
ENWW
Removing and installing components
109
