3
Support and troubleshooting
Solving common problems
The following table lists possible problems, the possible cause of each problem, and the recommended
solutions.
Problem
Possible Cause
Solution
Screen is blank or video is
flashing.
Power cord is disconnected.
Connect the power cord.
Monitor is turned off.
Press the rear panel power button.
NOTE:
If pressing the power button has no effect, press and
hold the power button for 10 seconds to disable the Power
Button Lockout feature.
Master power switch is set to off.
Set the master power switch on the rear of the monitor to the
On position.
Video cable is improperly connected.
Connect the video cable properly. Refer to
Connecting the
cables on page 5
for more information.
System is in sleep mode.
Press any key on the keyboard or move the mouse to
inactivate the screen blanking utility.
Video card is incompatible.
Open the OSD menu and select the Input Control menu. Set
Auto-Switch Input to Off and manually select the input.
Image appears blurred,
indistinct, or too dark.
Brightness setting is too low.
Open the OSD menu and select Brightness to adjust the
brightness scale as needed.
Check Video Cable is
displayed on the screen.
Monitor video cable is disconnected.
Connect the appropriate video signal cable between the
computer and monitor. Be sure that the computer power is off
while connecting the video cable.
Input Signal Out of Range is
displayed on screen.
Video resolution and/or refresh rate
are set higher than the monitor
supports.
Change the settings to a supported setting (see
Preset display
resolutions on page 23
).
The monitor is off but it did
not seem to enter into a low-
power sleep mode.
The monitor's power saving control is
disabled.
Open the OSD menu and select Power Control, select Auto-
Sleep Mode, and then set auto-sleep to On.
OSD Lockout is displayed.
The monitor's OSD Lockout function
is enabled.
Press and hold the
Menu
button on the rear panel for 10
seconds to disable the OSD Lockout function.
Power Button Lockout is
displayed.
The monitor's Power Button Lockout
feature is enabled.
Press and hold the power button on the rear panel for 10
seconds to unlock the power button function.
Button lockouts
Holding down the power button or
Menu
button under the right side of the bezel for ten seconds will lock out
the functionality of that button. You can restore the functionality by holding the button down again for ten
seconds. This lockout function is available only when the monitor is powered on, displaying an active signal,
and the OSD is not active.
Solving common problems
19
Summary of Contents for Z43
Page 1: ...User Guide ...
Page 4: ...iv About This Guide ...
