Tools required
Round hole and square hole racks
●
T-15 Torx screwdriver
Threaded hole racks
●
T-15 Torx screwdriver
●
Flat head screwdriver
●
Cross-tip screwdriver
For earlier HP racks including E3660B, E3661B, E3662B, J1450B, J1487A,
J1487B
●
T-15 Torx screwdriver
●
T-25 Torx screwdriver
●
M10 socket wrench
Step 1—Preparing the workstation
NOTE:
All illustrations are examples only. Workstation models vary. For product-specific information,
see the service guide for your HP workstation at
http://www.hp.com/support/workstation_manuals
before beginning installation.
To prepare the workstation for component installation:
1.
Power down the workstation and all external devices.
2.
Disconnect the workstation power cord.
3.
Disconnect all connections to external devices.
4.
Remove the side access panel.
ENWW
Tools required
3
