10.
If it is necessary to remove or replace the HD camera, disconnect the cable from the camera (1), and
then peel the silver tape up to remove the module from the enclosure (2).
The HD camera is available using spare part number L44581-001.
11.
If it is necessary to remove the display assembly from the computer:
a.
Disconnect the antennas from the WLAN module (1).
b.
Remove the antenna cables from the routing channel in the speaker (2).
c.
Disconnect the display cable from the system board ZIF connector (3), and then remove the cable
from the routing channel in the left speaker (4).
d.
Remove the four Torx T8 2.5×4.0 screws (1) that secure the display assembly to the computer.
58
Chapter 6 Removal and replacement procedures for authorized service provider parts
