78
M 322
Operator Manual
the pallet mounting points (figs.5).
- The machine consists of three main units (fig.5):
A casing
B head
C air tank (FS version only).
- After removing the head, preferably set it down in a horizontal position to prevent it
from falling over and being damaged.
5
Installing the arm
- Fit the arm, aligning with the holes for the pin
A (fig. 6), and fitting the 2 washers B above and
below the arm itself (fig.6).
- Fit the pin and tighten the screws C (fig. 6) until
slight resistance is felt when rotating the arm.
Fitting the column
- Fit the column onto the threaded studs.
- Fasten the column to the casing with the nuts
and washers A (fig.7).
C
A
B
A
B
C
B
6
C
Summary of Contents for M 322
