B 215 / B 225 Evo
Operator’s manual
123
UK
Pressing the START key the wheel does not spin (the machine
does not start)
➥
Contact the technical support centre.
The wheel balancer provides unsteady unbalance values
The machine was jolted during the spin.
➥
Repeat the spin, taking care not to disturb the machine while measuring is in pro-
gress.
The machine does not firmly rest on the floor.
➥
Make sure that the floor support is firm
The wheel is not locked correctly.
➥
Tighten the securing ring nut correctly.
Several spins are to be performed to balance the wheel
The machine was jolted during the spin.
➥
Repeat the spin, taking care not to disturb the machine while measuring is in pro-
gress.
The machine does not firmly rest on the floor.
➥
Make sure that the floor support is firm.
The wheel is not locked correctly.
➥
Tighten the securing ring nut correctly.
The machine has not been calibrated correctly.
➥
Carry out the sensitivity calibration procedure.
The entered geometric data are not correct.
➥
Check that the data corresponds to the dimensions of the wheel and correct, if
necessary.
➥
Perform the width sensor calibration procedure.
LED light and/or laser indicator are NOT working
➥
Check if the device(s) is (are) configured correctly as shown in the paragraphs “SET
UP - LED light ” and “SET UP - Laser indicator”. If the problem persists after checking
the correct device configuration, call the technical support centre.
CAUTION
The “Spare parts” handbook does not authorise the user to carry out work on the ma-
chine with the exception of those operations explicitly described in the User Manual.
It only enables the user to provide the technical assistance service with precise infor-
mation, to minimise delays.