Depending on the design of the keys, it may be necessary to use the Key
Retaining Plates on top of the jaws to hold the keys securely. These plates
are indexed on one side and may be flipped over to provide a more secure
hold.
To utilize the Key Retaining Plates, loosen the two set screws on each plate,
slide the plate over the key, and tighten the screws. Make certain that the plates
do not interfere with the tracks to be traced and cut.
Mini Groove™
8000MGDC
1/16'' Allen Wrench (#4.40 Buttonhead screw)
Note:
If interference is detected the
removal of plates and screws will be
necessary. They should be stored in
a location where they can easily be
retrieved for use when needed.
