network
example 1
Network -- "IP address change has not been completed"
network
suggested action 1
The
setnet
command was issued to change some network parameter, such as the IP address, but the
action has not been completed. Use
setnet finish
to complete the change, or
setnet abort
to
cancel. Use
shownet
to examine the current condition.
cli%
shownet
IP Address Netmask/PrefixLen Nodes Active Speed Duplex AutoNeg
Status
192.168.56.209 255.255.255.0 0123 0 100 Full Yes Changing
192.168.56.233 255.255.255.0 0123 0 100 Full Yes Unverified
network
example 2
Component ---Identifier---- -----Detailed Description----------
Network Node0:Admin Errors detected on network
network
suggested action 2
Network errors have been detected on the specified node and network interface. Commands such as
shownet
and
shownet -d
are useful for troubleshooting network problems. These commands display
current network counters as
checkhealth
compares error with the last logging sample.
NOTE:
The error counters shown by
shownet
and
shownet -d
cannot be cleared except by rebooting
a controller node. Because
checkhealth
is comparing network counters with a history log,
checkhealth
stops reporting the issue if there is no increase in error in the next log entry.
cli%
shownet -d
IP Address: 192.168.56.209 Netmask 255.255.255.0
Assigned to nodes: 0123
Connected through node 0
Status: Active
Admin interface on node 0
MAC Address: 00:02:AC:25:04:03
RX Packets: 1225109 TX Packets: 550205
RX Bytes: 1089073679 TX Bytes: 568149943
RX Errors: 0 TX Errors: 0
RX Dropped: 0 TX Dropped: 0
RX FIFO Errors: 0 TX FIFO Errors: 0
RX Frame Errors: 60 TX Collisions: 0
RX Multicast: 0 TX Carrier Errors: 0
RX Compressed: 0 TX Compressed: 0
pd
Displays physical drives (PDs) with states or conditions that are not optimal:
• Checks for failed and degraded PDs
• Checks for an imbalance of PD ports, for example, if Port-A is used on more Drives than Port-B
Troubleshooting
153
