Figure 37: Removing the DC power cooling module, controller node enclosure
Replacement
12.
Install the DC PCM.
a.
On the ESD mat, rotate the -48V DC PCM release handle to the open position and then carry it to
the enclosure.
b.
Slide the -48V DC PCM into the enclosure, and then push until the insertion mechanism starts to
engage (the handle starts to rotate).
IMPORTANT:
Ensure that no cables get caught in the PCM insertion mechanism.
c.
Close the handle until the latch clicks to fully seat the -48V DC PCM in the enclosure.
d.
Once inserted, pull back lightly on the PCM to ensure that it is properly engaged.
Figure 38: Installing the DC power cooling module, controller node enclosure
Service
49
