This symbol on an RJ-45 receptacle indicates a network interface connection.
WARNING:
To reduce the risk of electric shock, fire, or damage to the equipment, do not
plug telephone or telecommunications connectors into this receptacle.
This symbol indicates the presence of a hot surface or hot component. If this surface is
contacted, the potential for injury exists.
WARNING:
To reduce the risk of injury from a hot component, allow the surface to cool
before touching.
This symbol indicates that the component exceeds the recommended weight for one
individual to handle safely.
WARNING:
To reduce the risk of personal injury or damage to the equipment, observe
local occupational health and safety requirements and guidelines for manual material
handling.
These symbols, on power supplies or systems, indicate that the equipment is supplied by
multiple sources of power.
WARNING:
To reduce the risk of injury from electric shock, remove all power cords to
disconnect power from the system completely.
Rack warnings and cautions
WARNING:
When all components are removed, the system weighs 17.21 kg (37.94 lb). When all
components are installed, the system can weigh up to 22.65 kg (49.94 lb).
Before configuring your rack solution, be sure to check the rack manufacturer weight limits and
specifications. Failure to do so can result in physical injury or damage to the equipment and the facility.
WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
• The rack has anti-tip measures in place. Such measures include floor-bolting, anti-tip feet, ballast, or
a combination as specified by the rack manufacturer and applicable codes.
• The leveling jacks (feet) are extended to the floor.
• The full weight of the rack rests on the leveling jacks (feet).
• The stabilizing feet are attached to the rack if it is a single-rack installation.
• The racks are coupled together in multiple rack installations.
22
Removal and replacement procedures
Summary of Contents for Apollo z70
Page 18: ...18 Customer self repair ...
Page 19: ...Customer self repair 19 ...
Page 20: ...20 Customer self repair ...
Page 51: ...Drive power cabling Fan cabling Fan signal cabling Cabling 51 ...
