233
action syslog
Use
action syslog
to add a Syslog action to a monitor policy.
Use
undo action
to remove an action.
Syntax
action
number
syslog priority
level
facility
local-number
msg
msg-body
undo action
number
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
mdc-admin
Parameters
number
: Specifies an action ID in the range of 0 to 231.
priority
level
: Specifies the log severity level in the range of 0 to 7. A lower value represents a higher
severity level.
facility
local-number
: Specifies a logging facility by its facility number in the range of local0 to local7.
Facility numbers are used by a log host to identify log creation facilities for filtering log messages.
msg
msg-body
: Configures the log message body.
Usage guidelines
EAA sends log messages to the information center. You can configure the information center to
output these messages to certain destinations. For more information about the information center,
see "Configuring the information center."
You can configure a series of actions to be executed in response to the event specified in a monitor
policy.
EAA executes the actions in ascending order of action IDs. When you add actions to a policy, you
must make sure the execution order is correct.
If two actions have the same ID, the most recent one takes effect.
When you define an action, you may choose to specify a value or specify a variable name for an
argument. For more information about using EAA environment variables, see "
."
Examples
# Configure an action for the CLI-defined policy
test
to send a log message "hello" with a severity of
7 from the facility device
local3
.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 syslog priority 7 facility local3 msg hello
commit
Use
commit
to enable a CLI-defined monitor policy.
