59
Examples
# Create reaction entry 1 for monitoring the ICPIF value in the voice operation, and set the upper limit
to 50 and lower limit to 5. Before the voice operation starts, the initial state of the reaction entry is
invalid. After the operation, the ICPIF value is checked against the threshold range. If it exceeds the
upper limit, the state of the reaction entry is set to over-threshold. If it is below the lower limit, the
state is set to below-threshold. Once the state of the reaction entry changes, a trap message is
generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type voice
[Sysname-nqa-admin-test-voice] reaction 1 checked-element icpif threshold-value 50 5
action-type trap-only
reaction checked-element mos
Use
reaction checked-element mos
to configure a reaction entry for monitoring the MOS value in
the voice operation.
Use
undo reaction
to delete the specified reaction entry.
Syntax
reaction
item-number
checked-element
mos
threshold-value
upper-threshold lower-threshold
[
action-type
{
none
|
trap-only
} ]
undo
reaction
item-number
Default
No reaction entry for monitoring the MOS value is configured.
Views
Voice operation view
Predefined user roles
network-admin
mdc-admin
Parameters
item-number
: Assigns an ID to the reaction entry, in the range of 1 to 10.
threshold-value
: Specifies threshold range.
upper-threshold
: Specifies the upper limit in the range of 1 to 500.
lower-threshold
: Specifies the lower limit in the range of 1 to 500. It must not be greater than the
upper limit.
action-type
: Specifies what action to be triggered. The default action is
none
.
none
: Specifies the action of displaying results on the terminal display.
trap-only
: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.
Usage guidelines
You cannot edit a reaction entry after it is created. To change the attributes in a reaction entry, use
the
undo reaction
command to delete the entry, and then configure a new one.
For the MOS threshold, the number is expressed in three digits representing ones, tenths, and
hundredths. For example, to express a MOS threshold of 1, enter 100.
