343
Usage guidelines
The IPv6 NetStream hardware aggregation does not take effect in the following situations:
•
The destination host is configured for the IPv6 NetStream traditional data export in system view.
•
The aggregation mode set by the
ipv6 netstream aggregation
command is not supported by
the IPv6 NetStream hardware aggregation.
The IPv6 NetStream hardware aggregation entries are stored in the same cache as IPv6 NetStream
traditional data entries and are exportable.
Examples
# Enable the IPv6 NetStream hardware aggregation.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation advanced
Related commands
ipv6 netstream export host
ipv6 netstream aggregation
ipv6 netstream export host
Use
ipv6 netstream export host
to specify a destination host for IPv6 NetStream data export.
Use
undo ipv6 netstream export host
to remove the specified destination host or all destination
hosts that are configured in the current view.
Syntax
ipv6 netstream export host
{
ip-address
|
ipv6-address
}
udp-port
[
vpn-instance
vpn-instance-name
]
undo ipv6 netstream export host
[
ip-address
|
ipv6-address
] [
vpn-instance
vpn-instance-name
]
Default
No destination host is specified.
Views
System view, IPv6 NetStream aggregation mode view
Predefined user roles
network-admin
mdc-admin
Parameters
ip-address
: Specifies the destination IP address
.
Ipv6-address
: Specifies the destination IPv6 address
.
udp-port
: Specifies the destination UDP port number, in the range of 0 to 65535.
vpn-instance
vpn-instance-name
: Specifies an MPLS L3VPN instance to which the destination host
belongs. The
vpn-instance-name
argument is a case-sensitive string of 1 to 31 characters. If the
destination is on the public network, do not specify this option.
Usage guidelines
You cannot use the
display ipv6 netstream export
command to display information about the IPv6
NetStream aggregation mode that is not enabled.
You can specify the same destination host in different IPv6 NetStream aggregation mode views.
