• Server in rack mode:
Remove the server from the rack
on page 26.
• Server in tower mode: Place the server on its side and access panel facing up.
5.
Remove the PCIe air baffle.
Remove the system air baffle
Procedure
on page 25.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
• Server in rack mode:
Remove the server from the rack
on page 26.
• Server in tower mode: Place the server on its side and access panel facing up.
on page 29.
6.
Remove the system air baffle.
30
Remove the system air baffle
Summary of Contents for ProLiant ML110 Gen10
