Elliptical Cross
-
Trainer
&
Exercise Bike
5
Assembly Instructions
Preparation
1. Before assembling, make sure that you will have sufficient working space.
2. Use the tools provided for assembling.
3. Before assembling, check whether all needed parts are available. Refer to the
with all single parts (marked with numbers) which this equipment consists of.
Assembly
Figure 1
Attach the Front Stabilizer (No. 7) and the Rear
Stabilizer (No. 2) with four sets of Carriage Bolts
(N0. 4), Washers (No. 6) and Domed Nuts (No.
5).
N.B. The Front Stabilizer has the integral
transport wheels.
Figure 2
Insert the Spindle Bar (No. 22) through the Right
Lower Handlebar (No. 9) and through the main
frame and then through the arc washer (No. 36)
and the Left Handlebar (No. 10).
Put a D-shape Washer and a Spring Washer
(No. 20 & 21) on either side of the Spindle Bar
and tighten both ends using the Hinge Screws
(No. 19).
