EXB1 Recumbent Exercise Bike
E&OE
© 2017 HPF/Proflex
7
facing toward the seat and tensioner and wires remain in position and do not get caught or
pinched between the tubes.
9. Pull the cable connection bracket and all wiring (from main body and front mounting tube)
through the slot (
E
) in the front mounting tube, then connect the wiring (in any order), then tuck
the excess cable into the tube. Attach the front mounting tube to the main body using the 4
pre-assembled screws (
15
) and curved washers (
16
). Use the Allen key to firmly tighten
(rotate right) the screws.
10. Join the cable from the tension adjuster (
17
) (place the tensioning knob in the "1" position –
the tension cable will be at its longest at this setting) to the cable connection bracket (
D
)
protruding from the front mounting tube. The "ball" (
F
) on the end of the centre brace
tensioning cable must sit in the "hook" (
G
) in the connection bracket on the end of the main
body tensioning cable. Once the cable end is hooked into position, pull the cable collar (
H
) up
and over the slot (
I
) at the top of the cable connection bracket.
11. Carefully push the cable connection bracket down into the front mounting tube and place the
tension adjuster into position against the tube. Ensure that no cables etc are caught between
the adjuster and tube. Place the adjuster clamp (
J
) on the opposite side of the tube, then
secure the parts using the pre-assembled screw (
18
).
F
I
G
G
H
F
18
D
14
17
D
E
14
15
16
