Chapter Seven Operating instructions
Warning!
1
、
It is forbidden to run the engine without air filter. Oil with upper and
lower cutting lines should be added into the filter, otherwise the engine will wear
out faster.
2
、
Before starting the engine, the shift lever must be placed in neutral
position and the clutch handle is separated! Otherwise there will be casualties or
property damage accidents!!
3
、
In case of emergency, the engine should be quickly shut down and the
clutch handle released!
4
、
The microtiller must be run in before operation.
5
、
Do not suddenly release the starter handle to allow it to rebound and
damage the engine, should be slowly followed by the starter pull rope back to the
spring.
6
、
In the process of use, attention should be paid to the working condition
and sound of each part. Check whether the connection of each part is normal and
no looseness is allowed. If any abnormality is found, stop the machine to check
and eliminate it.
7
、
It is not allowed to start the cold car immediately after heavy load work,
especially the new machine or overhaul of the machine.
8
、
Pay attention to check the oil level of engine and transmission box.
9
、
Do not cool the engine with water.
10
、
The toppling of microtiller should be prevented during tillage.
11
、
It is strictly prohibited to install a rotary blade on the micro plow in the
sand or gravel pile driving, so as not to damage the blade.
12
、
After the use of farming, attention should be paid to remove soil, weeds,
oil stains attached to the micro-tillage machine, keep the machine clean.
13
、
Always clean the spongy body in the filter.
A
、
Start (note: shift lever must be in the middle neutral position)
a)
Start the diesel engine according to the steps specified in the diesel engine operating
instructions.
b)
The diesel engine should run for 2 ~ 3 minutes without load at idle speed (1500 ~
2000 RPM).
c)
Check whether the diesel engine is running normally, if not, stop the diesel engine
for maintenance.
B
、
Operation
Note: throttle cable adjustment is not good, will affect the normal use of the
product.
a)
Hung low gear
①
Press the throttle handle with your right hand, use the throttle in the minimum
position, and the engine is running at idle speed.
②
In the neutral position, pull back the operating lever with your right hand,
