and pay attention to whether you feel it in place, then hold the right handrail with your
right hand.
③
The right hand should appropriately increase the throttle, speed up the
operation, grasp the clutch handle, clutch joint, micro-tillage machine is running at a
slow speed of about 5km/h.
b)
gear up
①
Press the throttle handle with your right hand, use the throttle in the minimum
position, the engine is running at idle speed, the automatic clutch will automatically
separate.
②
Push the lever forward in neutral position with your right hand. And pay
attention to whether the feeling is in place, and then hold the right hand handrail.
③
The right hand is appropriate to increase the throttle, speed up the operation,
automatic clutch joint, micro-tillage machine is running at the speed of fast gear.
c)
Selecting reverse
①
Press the throttle handle with your right hand, use the throttle in the minimum
position, the engine is running at idle speed, the automatic clutch will automatically
separate.
②
Pull the lever to the middle neutral position with your right hand, and pay
attention to whether you feel it in place, then slowly grasp the reverse handle with your
left hand.
③
The right hand appropriately increases the throttle, speed up the operation,
automatic clutch engagement, micro plow back.
(note: do not release the reverse handle)
④
When you don't need to back up. Press the throttle handle with the right hand,
use the throttle in the minimum position, release the reverse handle with the left hand,
and the reverse gear is pulled out of engagement by the spring force.
d)
In the process of shifting gear, the engine throttle should be reduced first, (the
engine does not go out) automatic clutch automatic separation, when the machine will
stop walking, then shift gear.
e)
Turn, turn left or right by pulling the handrail.
(note: do not grasp the wrong handle of steering to avoid damaging the gear)
f)
Parking
①
The right hand moves the throttle handle to keep the throttle in the minimum
position. The engine operates at idle speed, the automatic clutch is in the state of
automatic separation, and the machine stops running.
②
When the engine needs to stop, should follow the engine operating
instructions related content.
(note that micro-tillers usually stop on flat land)
g)
emergency cut-off
①
During farming, when the throttle is in the minimum position, the clutch fails
to disengage (due to clutch failure) and the machine cannot be stopped. Emergency
parking is required at this time.
②
The left hand moves the pressure relief handle switch to make it in the
maximum state. The pressure-reducing valve at the engine is opened under the action
