manual before starting, and start after confirming safety.
b)
The oil door, clutch and other parts of the micro-tillage machine are flexible
and reliable. The rotating parts have no lag in rotation and the automatic return handle
is in normal position before starting.
c)
The automatic stop device of the blade shall not be controlled by means other
than manual control.
d)
Micro-tillage machine with steering mechanism, the right and left steering
clutch should be in a combined state.
F
、
field operation
a)
When slope work, should work along the slope direction.
b)
Before using reverse gear, stop the machine to remove the resistance bar, and
operate carefully after confirming safety.
c)
Turn off the engine before removing dirt, weeds, and other debris from the blade.
d)
When the ploughing knife falls into the soil and cannot advance, the engine
should be shut down and handled by human.
e)
When the operator leaves the operating position, shut down the engine and
remove the switch key.
f)
The operator must not operate fatigue, the engine should be shut down at rest.
g)
When replacing the operator in operation, the shift lever should be placed in
neutral to ensure that the power transmission between the engine and the gearbox is in
a state of separation.
G
、
Transfer
a)
The engine should be shut down before transfer and the walking wheel should
be replaced.
b)
If the ridge height or the width and depth of the ditch are greater than the
maximum turning radius of the plough blade, the engine should be shut down and
transported manually.
c)
When moving through the road, should comply with road traffic safety
regulations, and keep a safe distance from other vehicles and pedestrians.
d)
No person or object may be carried on the micro-tillage machine.
H
、
Stop check
a)
When one of the following situations is encountered in the operation of micro-
tillage machine, it shall stop the machine immediately for inspection:
-Ploughing knife wrapped grass, sticky mud serious;
-Abnormal sound of engine or transmission box;
-Abnormal increase of engine speed, throttle control failure;
-Other abnormal conditions.
Chapter Three Safety warning sign
