Chapter Five Form a complete set of requirements
Supporting power type
、
Designation:
1WG4.0-70FQ-ZC
、
1WG 4.0-105FQ-ZC
、
CB engine The engine of type v micro
- plough is air - cooled gasoline engine.
B
、
Supporting engine form and model:
Engine brand and model:1WG4.0-70FQ-ZC
、
1WG 4.0-105FQ-ZC
、
CB
enginetype I micro-tillage machine is 170F/P gasoline engine.
C
、
Requirements for supporting ploughing knife:
1WG4.0-70FQ-ZC The width of the design blade of type I micro-tiller is
all:700mm,1WG 4.0-105FQ-ZC
、
CB engine the width of the design blade of type I
micro-tiller is all:1050mm.
The standard configuration of ploughing knife is:Dry land ploughing knife, user
selection with ploughing knife, should be selected with the original factory ploughing
knife.
When the user needs to replace the engine, at least the engine of the same
type, power, speed, purpose and so on should be replaced, otherwise it cannot
match, and even cause damage to the machine and accidents.
If not according to the original factory design requirements supporting
power, plow knife, walking wheel, and change the original factory supporting
requirements, beyond the scope of use, machine damage and human injury and
death accidents will occur.
Chapter Six Installation method
A
、
Assembly after unpacking:
a
）
Fix the host and insert the hexagonal output shaft shaft into the hexagonal hole
of the output shaft sleeve at the lower part of the walking box assembly.
b
）
Use M6 * 16 hexagon socket screws to set the hexagon limit set on the
hexagon output shaft, so that the hexagon output shaft cannot move in the axial
direction.
c
）
Put the wheel:Install the wheels on both ends of the hexagonal output
shaft,And with two M8 * 55 bolts,M8 nut fixed.
d
）
Assembly of towing device:Insert drag rod box assembly in drag rod bearing
seat, with resistance rods inserted pin connection box and insert Φ 3*26, insert drag rod
inserted into the box slot, and load resistance with M8*55 after stick pin bolt, nut
positioning.
e
）
Installation of handrails:Put the two tooth discs on the support seat in the
positive direction, and pay attention to adjust the upper and lower positions of the
direction knob, which is attached with M16 * 140 bolts, plain pad 16, spring pad 16,
handle assembly connection and locking.
