VDPL601MHx14
28/11/2011
©
Velleman nv
7
•
A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an XLR
plug with a 120
Ω
resistor between pins 2 and 3, which is then plugged into the XLR output
socket
[5]
of the last device in the chain.
c) general
•
Have a qualified electrician carry out the electrical connection.
•
Connect the device to the mains with the power plug. All fixtures must be powered directly off
a grounded switched circuit and cannot be run off a rheostat or dimmer circuit, even if the
rheostat or dimmer channel is used solely for 0% to 100% switch.
•
The installation has to be approved by an expert before the device is taken into service.
d) Replacing the fuse [8]
•
Only replace the fuse by a fuse of the same type and rating.
•
Before replacing the fuse, unplug mains lead.
•
Unscrew the fuse holder on the rear panel of the base with an appropriate screwdriver.
•
Remove the old fuse and install the new fuse in the fuse holder.
•
Replace the fuse holder in the housing and tighten it.
6.
Operation
Refer to the illustrations on page
2
of this manual.
Control Panel Navigation
•
Access the control panel functions using the four panel buttons
[11]
located directly underneath
the display
[10]
. From left to right:
button function
<MENU> used to access the menu or to return to a previous menu option
<UP>
scrolls through the menu options in ascending order
<DOWN> scrolls through the menu options in descending order
<ENTER> used to select and store the current menu or option within the menu
•
The control panel display shows the menu items you select from the menu map. To select a
menu item, press <ENTER>.
•
Use the <UP> and <DOWN> buttons to navigate the menu map and menu options. Press
<ENTER> to access the menu function currently displayed or to enable a menu option. To return
to the previous option or menu without changing the value, press the <MENU> button.
Main menu functions
display description
press display
shows
remark
...
Set DMX starting address
between 1 and 512.
<UP>
<DOWN>
selected DMX
address
-
auto run mode - slow
<ENTER>
auto run mode - slow
auto run mode - fast
<ENTER>
auto run mode - fast
sound controlled mode
<ENTER>
sound mode enabled
run controlled
<ENTER>
run mode enabled
slave mode selection
<ENTER>
slave mode enabled
pan mode normal
<ENTER>
pan reverse
tilt mode normal
<ENTER>
tilt reverse
display normal
<ENTER>
display 180° rotated
14 channel mode
<ENTER>
8 channel mode
pan angle
<ENTER>
pan over 540°
pan over 360°
pan over 180°
tilt angle
<ENTER>
tilt over 270°
tilt over 180°
tilt over 90°
reset <ENTER>
-
load default settings
<ENTER>
-
