03
04
In
st
a
lla
tio
n
05
06
R
a
d
io
O
ve
rv
ie
w
Please unpack carefully and check that all items listed below are received.
If any item is missing or damaged, please contact your dealer.
Product Inspection
Items
Microphone Hanger
and Screws
Power Cord
Palm Microphone
Fuse
Mounting Bracket Kit
Radio DM-9800
User Manual
Before you install the radio in a vehicle, be sure to read
the following instructions carefully:
A. Install the bracket in a location where it's easy
to operate the radio.
B. Connect accessories such as antenna and
power cord to the radio.
C. Slide the radio into the mounting bracket and
secure it using the locking knobs.
D. Install the microphone hanger in a location where
it can be reached easily.
E. Plug the palm microphone into the microphone
jack on the front panel (but at first align the triangle
index on the palm microphone with the microphone
installation index), and place it on the hanger when
you do not use it.
Installation
Instructions
•
The radio operates with cathode-grounded power
supply of 13.6V ± 15% only. Please check polarity and
voltage of the power supply on the vehicle before you
install the radio.
Please check how long the screws will extend from
the bottom surface of the radio, before you install
the radio. Drill the mounting hole cautiously to avoid
damage to the vehicle wiring and other parts.
Please connect HQT supplied antenna and power
cord to the radio, before you install it in the bracket.
And make sure the antenna and power cord is
dedicated for HQT digital radios.
Install the radio with HQT supplied mounting bracket,
to avoid radio looseness in case of accidents. The
loose radio may cause bodily injury.
Install the radio in a location where it's easy to reach
the front panel controls.
Please make sure there's sufficient space at back
of the radio for wiring.
When the fuse for DC power cord needs replacement,
it must be replaced by a fuse with the same specification.
•
•
•
•
•
•
Installation Tools
•
•
•
Electric drill
Cross head screwdriver
Hex socket sleeve (used for 4.8*20mm self-tapping
screws)
Installation Steps
No.
Part Name
1
Radio Unit
2
RF Antenna Connector
3
Locking Knobs
4
Mounting Bracket
5
4.8*20 mm Self-tapping Screws
6
Power Inlet
7
Black Power Cord
8
Red Power Cord
9
Fuse
10
Palm Microphone
11
Microphone Hanger
12
4*16 mm Self-tapping Screws
13
GPS Antenna Connector
Radio Overview
No.
Part Name
No.
Part Name
1
Volume Control/Channel
Selector/Power On-Off Knob
2
LED Indicator
3
LCD Display
4
5
Back Key
6
7
8
Up/Down Keys
9
Speaker
10
Programmable Keys
11
Select Key
12
Front Panel
Rear Panel
No.
Part Name
No.
Part Name
1
RF Antenna Connector
2
Power Inlet
3
Accessory Jack
4
GPS Antenna Connector
Emergency Key
Programmable Key
Programmable Key
Palm Microphone Jack
P
ro
d
u
ct
In
sp
e
ct
io
n
In
st
a
lla
tio
n
